NEW New Lumi CALO setup and monitor with old DCS

To monitor the NEW setup of the NEW Lumi Calorimeter and currents you can check it at http://l0padme3:9090/dcs the standard General/DCS_summary page (status continuously displayed each 180 secs).

Now ALL the target voltages are managed through one of the CAEN Ecal HV boards (board 16 - channel 35). There is NO NEED to connect directly to the CAEN HV supply via ssh !

To set ON/OFF the target you have to log onto dcs@l0padme1 and type the following (self-explanatory) commands :

onvolt_calolumi --> sets ON at the standard HV set on the CAEN crate for the target

offvolt_calolumi --> sets OFF the Calo Lumi HV

setvolt_calolumi hv --> sets ON at the specified hv value the Calo Lumi channel

if you do not specify a voltage (float!) you will be asked for one (<1100 or it will say you it's invalid and asks again)