Tgfx start

If you want get started using tgFX with your TinyG hardware then this is the place to be!

First off what we need to do is make sure we have everything that we will need to get tgFX to connect to your TinyG controller.

##You Will Need:

1. A USB cable. (Type A printer cable)
2. A PC or OSX computer.
3. tgFX Binary downloaded for your platform. [See - Downloads]
4. A TinyG or ArduinoDUE that has been flashed with the g2 TinyG firmware Port [See - flashing g2]

##Connecting tgFX As mentioned above you will need a type A-B usb cable. Otherwise known as a USB printer cable. The TinyG wiki already has the documentation on how to connect your TinyG to your computer so we will not go over it here. You can read how to connect your TinyG to your computer here. From here we will assume that your computer is connected to your TinyG, your TinyG is powered and your FTDI serial port drivers are installed for your platform (the g2 port of TinyG does not require FTDI drivers).