Use io.Copy instead of io.CopyBuffer (#85) #46

	name: Test
	on:
	push:
	branches:
	- '**'
	pull_request:
	branches:
	- '**'

	jobs:
	test:
	name: Test wireproxy
	runs-on: ubuntu-latest
	steps:
	- uses: actions/checkout@v2
	- name: Setting up Go
	uses: actions/setup-go@v2
	with:
	go-version: "1.20"
	- name: Install dependencies
	run: sudo apt install wireguard curl
	- name: Building wireproxy
	run: \|
	git tag dev
	make
	- name: Generate test config
	run: ./test_config.sh
	- name: Start wireproxy
	run: ./wireproxy -c test.conf & sleep 1
	- name: Test socks5
	run: curl --proxy socks5://localhost:64423 http://zx2c4.com/ip \| grep -q "demo.wireguard.com"
	- name: Test http
	run: curl --proxy http://localhost:64424 http://zx2c4.com/ip \| grep -q "demo.wireguard.com"
	- name: Test http with password
	run: curl --proxy http://peter:hunter123@localhost:64424 http://zx2c4.com/ip \| grep -q "demo.wireguard.com"
	- name: Test http with wrong password
	run: \|
	set +e
	curl -s --fail --proxy http://peter:wrongpass@localhost:64425 http://zx2c4.com/ip
	if [[ $? == 0 ]]; then exit 1; fi

Provide feedback