FilamentDryer_Controller

Arduino OLED Rlelay and DS18B20 to control heater element of a 3D printing Filament dryer.

/*

• 3D Printing Filament Dehydrator Control Module

• This sketch will control the heater element(s) of a standard Food Dehydrator

• to enable drying various 3d printing filament to their suggested dryinh tempertaure and time.

• An Arduino is used to display and capture menu selections through 3 momentary push buttons.

• Pre stored values for targetted temperature will be compared to the inputs from a DS18b20 Dallas digital temperature sensor.

• Results of this comparision will then be used to control the heater element relay via 5v signal.

• ####-WARNING-#### Timer function is ONLY for reference, NO ACTION to the dehydrator will be executed by the module through timer functions.

• The reason for this non-action is to prevent the filament to re-absorb humidity in case of long running time after auto-shutdown of heater element.

• Buzzer / Alarm might be added in the future

• BOM (Bill of Material):

• Qty - Desc

• 1 - Arduino Pro-Mini or other

• 1 - OLED Display

• 1 - DS18B20 Dalla temp sensor

• 1 - Single Relay Module

• 1 - 120/220VAC to 5DC converter (Any phone charger or other adapter

• 3 - Momentary on Push Buttons

• 3 - 10K Resistor

• 1 - 4.7K Resistor

• Wiring Diagram..........:

• 3D printed enclosure....:

• This code GitHub........: https://github.com/MirageC79/FilamentDryer_Controller

• Library Used: (V1.1)

• • OneWire.h from Paul Stoffregen...............https://github.com/PaulStoffregen/OneWire
• • Addafruit GFX:...............................https://github.com/adafruit/Adafruit-GFX-Library
• • Addafruit SSD1306............................https://github.com/adafruit/Adafruit_SSD1306
• • Arduino Temperature Control by milesburton...https://github.com/milesburton/Arduino-Temperature-Control-Library

• Created by:

• Olivier Royer-Tardif (alias MirageC)

• October 12th, 2018

• Revision Log:

• Version DATE DESC RELEASED BY:

• V1 12-Oct-2018 Initial release Olivier Royer-Tardif

• V1.1 05-Jan-2019 Library Used listed Olivier Royer-Tardif

• Known Bugs

• 1 - Memory issue if any additionnal variables added.

• 2 - "Set Timer" menu not functionnal

*/