Orbion Hardware Rev. 2.5

New add

• Other 2 rear button
• Insert for reset button
• Timeout display and Neopixels (Default set 1min)
• Two version for right-handed & left-handed (Top_Left or Top_Right file)
• New support for USB type interchangeable
• Different method for inserting the OLED display
• Axial bearing in the knob to avoid strange oscillations
• Clip to secure cables in place
• multiple cable routes for the Arduino support
• new knob hooking system to prevent deformed prints

Fixed

• wobbly knob rotation
• display attachment system not always compatible and unstable

All the parts can be printed in the material of your choice except the Wire_clips and cuschion which must be exclusively in TPU Shore 95A or 85A.

The Spacers must also be printed, they will be positioned as the last component after inserting the knob_support on the D-shaft. Any rigid material is fine

The Top_Left and Top_Right versions are to be printed based on whether you are right-handed or left-handed.

Orbion Firmware Rev. 0.26.5

New add

• Add Brightness settings
• Loop menu
• Timeout display and Neopixels (Default set 1min)

Fixed

• Button bounce
• Inhomogeneous joystick axes
• Smoother menu
• Accidental scrolls during knob movement (encoder disabled during movements)

On the main page you will find the HowToFlashing.pdf file with a small step by step guide to load and flash the new firmware with PlatformIO

Orbion Firmware Rev. 0.26.4

From this version it will no longer be necessary to use Arduino IDE

which will be replaced by Visual Studio Code with the PlatformIO plugin

On the main page you will find the HowToFlashing.pdf file with a small step by step guide to load and flash the new firmware with PlatformIO

New add

• Add other 2 Buttons settings
• Neopixels item menù
• Timeout display and Neopixels (Default set 1min)

Fixed

• non-smooth rotation
• menu that froze
• SRAM memory full
• Serial busy (due to uncontrolled cycles)
• unused libraries

We also inform you that: the firmware uses a different wiring diagram as well as additional components such as the Neopixel, so it is recommended to use the firmware with the HARDWARE 2.5 version

For all those who have already run the project previously, they must use the "OLD" firmware versions. In case you want to use the new implementations such as the neopixels, you need to make some changes to the knob and add 1 cable for controlling the LEDs as well as correctly setting the pins of your project. for help ask about Discord