Rasbperry Pi Visualizer works once, time when open a gcode; then no more...

[davemaster]

Version

2.1.8

Hardware / Firmware

GRBL 0.9

What happened

When I open UGS 2.1.8 (in Windows 10, and In Raspberry Pi 5), all works fine, I open a gcode file, it shown the lines into the visualizer, but, When I play to start doing the job, the lines, all of them in visualizer vanished, also but for a moment, when I connect the Arduino with firmware 0.9j (with PEN support). Searching, I found that the UGS 2.0.13( RPi 5), the platform version works perfect as shown in the picture bellow...

What should it be? Is the 2.0.13 version done for work with grbl 0.9j ???

Also works on Windows 10, the UGS Platform as shown bellow:

But with 2.1.8 (Raspberry Pi 5) and 2.1.6 (Windows 10) the failure shown in video bellow:

UGS.2.1.6.-.8.visualizer.fails.to.show.gcode.mp4

Thanks in advance

How to reproduce

No response

Operating System

Windows 10, Raspbian wayland (RPi 5)

Anything else

No response

[breiler]

Can you give me a sample gcode file where this happens. And I also would like the log file (Go to the menu Tools -> Open log directory).

[davemaster]

Ok, the log attached, is from the RPi 5, running UGS 2.1.8 Also, the gcode, but NO MATTER what gcode is, it happens; not with the 2.0.13 Platform, it does sweet... Thanks in advance PD: My firmware, GRBL 0.9j - servo support (M3S15, AND M3S40) El mié, 4 sept 2024 a las 3:55, Joacim Breiler ***@***.***>) escribió:

…

Can you give me a sample gcode file where this happens. And I also would like the log file (Go to the menu Tools -> Open log directory). — Reply to this email directly, view it on GitHub <#2599 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AAIGUX3VVQPC7AISNIRJV2DZU3DILAVCNFSM6AAAAABNTVRDJKVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDGMRYGI4TENJZGA> . You are receiving this because you authored the thread.Message ID: ***@***.***>

-- David Elias Flores Escalante TeleTracking SAC

[breiler]

You need to attach files through github, email attachments does not work.

[davemaster]

You need to attach files through github, email attachments does not work.

Ok,
here they are zipped
rewinderuniversalgcodesenderrasbperrypivisualizer.zip

[breiler]

The log contains why this problem occurs.

Can you right click in the console and choose "Enable verbose logging" and let it spew a couple of lines (then you can disable it again). Then copy them here, I just want see a couple of status report lines.

I would also like you to copy the output from the command $$.

[davemaster]

The log contains why this problem occurs.

Can you right click in the console and choose "Enable verbose logging" and let it spew a couple of lines (then you can disable it again). Then copy them here, I just want see a couple of status report lines.

I would also like you to copy the output from the command $$.

Ok, as soon as possible... Thanks