What is your setup?

[moelski]

Hi !

I saw this project a while ago and always wanted to try it out. But there are some questions left ...
So this is not an issue. More some questions about practical usage :-)

1. At the moment I use estlcam with it's Windows frontend. What did you use with this klipper impementation? Will it work with MainSail and fluid? Or are there some other UIs ?
2. What did you use for generating the GCode? I could still use estlcam for that. But it would make the whole workflow more complicated I think.
3. I have some high power stepper driver. Something similar to DM542. Can I use these steppers? Basically I only need to connect DIR, STEP, Enable - right?

So in general it would be really nice if you can tell a little bit about your setup and your software workflow.
Thx in advance
Dominik