You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Now, when I connect to the camera's serial interface, it only displays "<<" and "hw:x", sometimes "sf:err" as well. I can still enter commands, but there is no response.
Since I've read that flashing the uboot bootloader by EliasKotlyar is not possible on ARM processor models, I wanted to ask if there's anything else I can do or if I have to consider this as a lesson learned.
Thank you in advance for your responses!
Martin
The text was updated successfully, but these errors were encountered:
Hello,
I bricked my Xiaofang camera with an ARM chip by following the instructions on https://github.com/EliasKotlyar/Xiaomi-Dafang-Hacks/blob/master/hacks/flashinguboot.md. Unfortunately, I realized too late that this hack is only applicable to Ingenic T20 processors.
Now, when I connect to the camera's serial interface, it only displays "<<" and "hw:x", sometimes "sf:err" as well. I can still enter commands, but there is no response.
Since I've read that flashing the uboot bootloader by EliasKotlyar is not possible on ARM processor models, I wanted to ask if there's anything else I can do or if I have to consider this as a lesson learned.
Thank you in advance for your responses!
Martin
The text was updated successfully, but these errors were encountered: