How to get the baseline light curve?

[hmjin1]

Hi, I'm a Phoebe user, i have a question. i use Phoebe get a binary's light curve, it's flux default consider the ellipsoidal,reflection,boosting effect ...,reference ‘The theory and design principles of PHOEBE’ Figure 5.8. I want to get a baseline light curve ,how to set the parameter and set which parameter when get the light curve? Any wisdom would be greatly appreciated!

[kecnry]

Baseline here just means the same system parameters but without distortion (to remove ellipsoidal contributions) and without reflection & boosting. As of the 2.2 release PHOEBE currently no longer supports boosting, so you don't need to do anything unless you're using an older version (in which case you can set boosting_method='none'). To disable reflection/irradiation, you can set irrad_method='none', and to turn off surface distortion/ellipsodal effects, you can set distortion_method='rotstar' or distortion_method='sphere'.

Hope this helps!
Kyle

[hmjin1]

Thank you very much! Follow your advice, i get the baseline lc.It is much to be regretted that i could not meet Phoebe earlier, it's a very useful software in simulation.