You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
For the One Channel Vibration Plus sensor, I check the box for Auto Config, then check the box on 'Measurement Mode' and try to change it to the second value in the dropdown.
When I click Done, and then go back into the same node, my changes done above are not saved/persisted:
Are we not able to modify this setting yet perhaps?
The text was updated successfully, but these errors were encountered:
If I check every optin in the 'Auto Config' section, click Done, and then re-enter the node, most of the options remained checked, but I noticed a few others that return to unchecked:
For the One Channel Vibration Plus sensor, I check the box for Auto Config, then check the box on 'Measurement Mode' and try to change it to the second value in the dropdown.
When I click Done, and then go back into the same node, my changes done above are not saved/persisted:
Are we not able to modify this setting yet perhaps?
The text was updated successfully, but these errors were encountered: