Support for OLimex Lime 2 [Documentation Feature]

[ncorder]

Hello everyone,

I hope this finds you in the absolute best of health.

I am writing this issue request in hopes to provide documentation for flashing using the Lime2 board by Olimex [1]. I am still a bit newer to BIOS flashing but confident I can help contribute.

My assumption is that in order to flash users would need the A20-OLinuXino-LIME2-UEXT, LIME GPIO2 LCD STEP ADAPTER however I could be wrong.

Would it be correct in stating that I should just transliterate the RPI pins?

Pin Number	Clip (25xx signal)	Raspberry Pi	OLimex Lime 2
1	CS	24	uncertain
2	MISO	21	39
3	not used	not used	not used
4	GND	25	2
5	MOSI	19	37
6	CLK	23	31
7	not used	not used	not used
8	3.3V		3

Thank you so much for any help you can provide. As well as for helping create such a wonderful project.