Skip to content

Latest commit

 

History

History
32 lines (22 loc) · 2.65 KB

README.md

File metadata and controls

32 lines (22 loc) · 2.65 KB
Raw

Secplus GDO for ESPHome

Secplus GDO is an ESPHome component for controlling Security+ and Security+ 2.0 garage openers made by Chamberlain Group, including garage door openers sold since 1997 under the Chamberlain, LiftMaster, Craftsman and Merlin brands.

This component is maintained by Konnected and powers the Konnected GDO blaQ Konnected's smart garage door opener accessory for Security+ garage door openers.

Adapted from ratgdo

This component was adapted from and inspired by ratgdo, however it's not a copy and not feature-equivalent. We initially set out to fork ratgdo and contribute back some improvements, however it ultimately became a complete rewrite. Konnected is publishing this derivative work under the GPLv3 license.

Project Goals

The ratgdo and secplus developers found a way to communicate with Security+ garage door openers over a reverse-engineered serial wireline protocol. This novel development enabled owners of Security+ garage openers to read and send commands directly to the garage unit. Konnected set out to incorporate this technology into a finished consumer product. To do that, we wanted to adapt the code to:

  • Remove dependency on Arduino
  • Run on the ESP-IDF platform
  • Utilize the ESP32's hardware UART (instead relying on the SoftwareSerial arduino library)
  • Decouple the Security+ wireline protocol from the ESPHome component

Other Differences from ratgdo

  1. Event-driven instead of polling. This library uses an event-driven architecture to receive data from the garage door unit, instead of polling for updates. This results in a measurably faster response time to state changes.
  2. Two wires instead of three. The obstruction sensor state can now be read via the serial protocol, therefore it doesn't need to be wired separately to a GPIO. This makes installation simpler, only requiring the red and white wire to the wall button inputs on the garage door opener.
  3. Supports a pre-closing warning. To comply with U.S. 16 CFR 1211.14(f)
  4. Automatic detection of Security+ vs Security+ 2.0. Less for the end-user to think about.
  5. Removes dry contact trigger support. We feel that this is better handled with a template cover in ESPHome, and this library should focus on the Security+ interaction only.
  6. Removes relay outputs. Again, simplifying the library to do Security+ only.

Dependencies

  1. gdolib (to be published soon)