Created by: Hello Robot Inc
This tool allows a tablet to be attached to the Stretch wrist. The design uses an off-the-shelf swivel phone holder, two 3D printed adapter plates, and a die-cut double stick tape..
| Item | Qty | Vendor |
|---|---|---|
| M3x10mm SHCS | 2 | McMaster-Carr |
| Double stick mounting tape 2 3/8" | 1 | Amazon |
| swivel_adapter_top.STL | 1 | PLA 3D printer |
| swivel_adapter_bottom.STL | 1 | PLA 3D printer |
| tablet_tape_adapter.STL | 1 | PLA 3D printer |
| Magnetic car phone holder | 1 | Amazon |
- Remove the rubber cover from the phone holder. You'll see metal plate holding the magnets. Remove the metal plate with a screw driver.
- Attach the 'tablet_tape_adapter' to the phone holder, reusing the screw you just remove. Note: If the adapter does not sit flat you may want to clip the plastic 'L' tabs from the holder using side cutters.
- Unscrew the large nut on the phone holder and disengage the ball from its socket.
- Remove the red sticker from the phone holder, exposing the double stick tape. Stick the phone holder firmly onto the 'swivel adapter'
- Attach the swivel adapter to the top of the Stretch wrist using the M3 bolts
- Attach the tablet_tape_adapter to your tablet in the desired position using the 'double stick mounting tape'
- Finally, insert the ball back into the socket of the phone holder. Attach firmly using the large nut.