iniatal update after first Home Assistant integration stops.

[thogitnet]

I have put a new Home Assistant Voice into operation. As in the instructions via Phone.
PS: In the instructions, it would be good to note that Bluetooth must be allowed for the app ...

The update from 24.10.15 to version 25.1.0 was then started immediately. The update stopped at 16%. After more than an hour, I restarted the Home Assistant Voice by power reconnect. However, the next attempt did not get past 3% and I canceled my last attempt at 6%.

Is this behavior known?
Should I do an update with esphome ota ? If so what is the correct image ?

[timkolloch]

I have a similar problem - the first 85% worked without a problem but now 1,5 hours later I am at 93% :(

[fhk1407]

I have put a new Home Assistant Voice into operation. As in the instructions via Phone. PS: In the instructions, it would be good to note that Bluetooth must be allowed for the app ...

The update from 24.10.15 to version 25.1.0 was then started immediately. The update stopped at 16%. After more than an hour, I restarted the Home Assistant Voice by power reconnect. However, the next attempt did not get past 3% and I canceled my last attempt at 6%.

Is this behavior known? Should I do an update with esphome ota ? If so what is the correct image ?

Yes, see #297 below. Same thing.

[thogitnet]

I wanted to take another look at the problem and connect using the esphome logs command. When I started the update, it went through in about 60 seconds and I was able to start the setup. Funny thing.

[rlust]

Same issue I think, started new device, then it wanted to do an update. Has been 15 minutes and only 1%!