-
Notifications
You must be signed in to change notification settings - Fork 1
Legacy:Tests
This app is a command-line interactive interface to test the driver and the device. You can issue commands on STDIN and the response will be written to STDERR.
This command reads the device status and outputs in a table-like structure.
The first 4 cells are the measured voltages on different pins in ###.## format
The fifth is the current flowing out on VCC
The sixth consists of 3 flags: * (VCC on), + (overcurrent detected) and - (reverse current detected). The column has a . if that flag is TRUE and is left blank otherwise
The seventh similarly has all the resources-in-use flags: JTAG, CLK1, CLK2, RST, Serial IO, EP1&EP2, EP3&EP4
This command reads the clock's status (whether it is active; current values of the registers)
This command gets the power limit, as well as the correction values (the latter as a hex dump)
Setting the VCC pin
Performs a JTAG scan and outputs the devices' identifiers
Bye