Legacy:Tests

Legacy driver - logsys-test binary

This app is a command-line interactive interface to test the driver and the device. You can issue commands on STDIN and the response will be written to STDERR.

status

This command reads the device status and outputs in a table-like structure. The first 4 cells are the measured voltages on different pins in ###.## format

The fifth is the current flowing out on VCC

The sixth consists of 3 flags: * (VCC on), + (overcurrent detected) and - (reverse current detected). The column has a . if that flag is TRUE and is left blank otherwise

The seventh similarly has all the resources-in-use flags: JTAG, CLK1, CLK2, RST, Serial IO, EP1&EP2, EP3&EP4

clk status

This command reads the clock's status (whether it is active; current values of the registers)

pwrlim get

This command gets the power limit, as well as the correction values (the latter as a hex dump)

vcc on and vcc off

Setting the VCC pin

jtag scan

Don't

quit

Bye