README.md

ratgdo for ESPHome

This is a port of the ratgdo software for the v2.0/v2.5 board to ESPHome.

Note: This fork includes a change in setting the Obstruction Sensor to read the GDO state rather than direct from the sensors. This is essential to support 2 pairs of sensors.

Visit the github.io page to purchase boards

Installation

• Flash the ESPHome based firmware using the Web Installer

It is no longer necessary to save the rolling code counter when switching between firmware.

First use after adding to Home Assistant

The ESPHome firmware will allow you to open the door to any position after calibration. To calibrate the door, open and close it once without stopping.

ESPHome config

• Security+ 2.0 for v2.0 board with ESP8266 D1 Mini

• Security+ 2.0 for v2.0 board with ESP8266 D1 Mini lite

• Security+ 2.0 for v2.0 board with ESP32 D1 Mini

• Security+ 2.0 for v2.0 board with ESP32 Lolin D2 Mini

• Security+ 2.0 for v2.5 board with ESP8266 D1 Mini

• Security+ 1.0 for v2.5 board with ESP8266 D1 Mini

• Security+ 2.0 for v2.5 board with ESP8266 D1 Mini lite

• Security+ 1.0 for v2.5 board with ESP8266 D1 Mini lite

• Security+ 2.0 for v2.5 board with ESP32 D1 Mini

• Security+ 1.0 for v2.5 board with ESP32 D1 Mini

• Security+ 2.0 for v2.5i/2.52i/2.53i board

• Security+ 1.0 for v2.5i/2.52i/2.53i board

• Web Installer